Shift on the fly system oil replacement

1) Remove the shift-on-the-fly actuator from the housing.

1) Clean the contact surface of the housing and shift-on-the-fly actuator.

2) Apply LOCTITE FMD-127 or equivalent to the contact surface between the shift-on-the-fly actuator and the housing.

3) Remove any old sealing agent from the bolt and threaded hole.

4) Apply LOCTITE FMD-127 or equivalent to the bolt.

5) Install the shift-on-the-fly actuator to the housing.

Tightening torque: 9 N・m { 0.9 kgf・m / 80 lb・in }

1. Regarding lubricant type

For the lubricant type, refer to the following.

Refer to "201.General Information 14B.Vehicle Information recommended fluids, lubricants and diesel fuels".

2. Lubricant refill procedure

1) Remove the filler plug and gasket from the housing.

2) Add shift-on-the-fly system oil to the housing.

Legend

3) Install the filler plug and gasket to the housing.

Tightening torque: 50 N・m { 5.1 kgf・m / 37 lb・ft }