Map light bulb removal

1. Preliminary and post procedures

1. Preliminary procedures

1) Disconnect the battery cable from the battery negative terminal.

Caution

  • After turning OFF the ignition switch (power mode for models with passive entry and start system), do not disconnect the battery cable within 3 minutes.
  • If the battery cable is disconnected within 3 minutes, the vehicle electronic control system may malfunction.
  • If the battery cable is disconnected, perform the setting of the front door power window switch with AUTO UP/AUTO DOWN function after connecting the battery negative terminal.

2. Map light removal

1) Insert a small flathead screwdriver, etc., into the gap between the head lining and the map light to unlock the claw section.

2) Remove the map light from the head lining.

Caution

  • Do not remove the map light with the claw section locked.

Legend

  1. Claw section
  2. Map light

3) Disconnect the connector from the map light.

3. Map light bulb removal

1) Remove the map light bulbs from the front map light and rear map light.

Front side

Legend

  1. Socket
  2. Map light bulb
  3. Front map light

Rear side

Legend

  1. Socket
  2. Map light bulb
  3. Rear map light
Copyright Mazda Motor Corporation. All rights reserved.