DTC P117A:00 [SKYACTIV-G 2.0, SKYACTIV-G 2.5]
id0102h4316900
|
DTC P117A:00 |
Engine oil temperature is high |
|---|---|
|
DETECTION CONDITION
|
Type A VIN
• With the transmission in 4th gear or lower gear, an engine speed of 6,100 rpm continues for 6 min.
Type B VIN
• With the transmission in 5th gear or lower gear, an engine speed of 6,100 rpm (SKYACTIV-G 2.0)/5,800 rpm (SKYACTIV-G 2.5) continues for 6 min.
Diagnostic support note
• This is a continuous monitor (other).
• The check engine light does not illuminate.
• FREEZE FRAME DATA (Mode 2)/Snapshot data is not available.
• DTC is stored in the PCM memory.
|
|
FAIL-SAFE FUNCTION
|
• Limits intake air amount
|
|
POSSIBLE CAUSE
|
• High engine speed condition continues
• PCM malfunction
|
|
SYSTEM WIRING DIAGRAM
|
Not applicable
|
Diagnostic Procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
2
|
VERIFY RELATED PENDING CODE AND/OR DTC
• Switch the ignition off, then ON (engine off).
• Perform the Pending Trouble Code Access Procedure and DTC Reading Procedure.
• Is the PENDING CODE/DTC P0335:00 also present?
|
Yes
|
Go to the applicable PENDING CODE or DTC inspection.
|
|
No
|
Go to the next step.
|
||
|
3
|
INSPECT EFFECT OF VEHICLE CONDITION FOR MALFUNCTION
Type A VIN:
• Verify how the customer drives the vehicle by asking the customer the following:
• Does the engine speed exceed 6,100 rpm for 6 min or more while driving in 4th gear or lower gear?
Type B VIN:
• Verify how the customer drives the vehicle by asking the customer the following:
• Does the engine speed exceed 6,100 rpm (SKYACTIV-G 2.0)/5,800 rpm (SKYACTIV-G 2.5) for 6 min or more while driving in 5th gear or lower gear?
|
Yes
|
Type A VIN:
• Explain to the customer that the vehicle is normal. (malfunction caused by continuous engine speed exceeding 6,100 rpm for 6 min or more while in 4th gear or lower gear)
• If there is a concern with customer’s driving, provide the customer some pertinent advice (such as gear selection, how to use manual mode).
Type B VIN:
• Explain to the customer that the vehicle is normal (performs control to protect the engine due to continuous engine speed exceeding 6,100 rpm (SKYACTIV-G 2.0)/5,800 rpm (SKYACTIV-G 2.5) for 6 min or more while in 5th gear or lower gear).
• If there is a concern with customer’s driving, provide the customer some pertinent advice (such as gear selection, how to use manual mode).
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Always reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the M-MDS.
• Perform the Drive Mode 03 (Variable Valve Timing, A/F Sensor Heater, HO2S Heater, A/F Sensor, HO2S and TWC Repair Verification Drive Mode).
• Is the same DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the PCM.
Go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||