DTC P1886:00

id030200200400

DTC P1886:00

Configuration data not recorded

DETECTION CONDITION

•  4WD CM detects vehicle type information data error

FAIL-SAFE FUNCTION

•  Control disabled.

•  4WD warning light: Illuminated

POSSIBLE CAUSE

•  PCM malfunction

•  Wrong 4WD CM is installed

Diagnostic procedure

STEP	INSPECTION		ACTION
1	INSPECT FOR PCM MALFUNCTION • Switch the ignition to off. • Using the M-MDS, perform the DTC inspection for the PCM. (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-D 2.2].) • Are any DTCs detected?	Yes	Go to applicable DTC inspection. (See DTC TABLE [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See DTC TABLE [SKYACTIV-D 2.2].)
1		No	Go to the next step.
2	INSPECT THE 4WD CM • Is correct 4WD CM installed?	Yes	Replace the 4WD CM. (See 4WD CONTROL MODULE REMOVAL/INSTALLATION.)
2	INSPECT THE 4WD CM • Is correct 4WD CM installed?	No	Go to the next step.
3	COUPLING COMPONENT CALIBRATION DATA WRITING • Write the coupling component calibration data. (See COUPLING COMPONENT CALIBRATION DATA WRITING.) • Clear the DTCs from the memory. (See ELECTRONIC 4WD CONTROL SYSTEM ON-BOARD DIAGNOSIS.) • Is the same DTC present?		Go to the next step.
4	VERIFY THAT THE SAME DTC IS NOT PRESENT • Clear the DTCs from the memory. (See ELECTRONIC 4WD CONTROL SYSTEM ON-BOARD DIAGNOSIS.) • Is the same DTC present?	Yes	Repeat the inspection from Step 1.
4		No	Go to the next step.
5	VERIFY THAT NO OTHER DTCS ARE PRESENT • Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See ELECTRONIC 4WD CONTROL SYSTEM ON-BOARD DIAGNOSIS.)
5		No	DTC troubleshooting completed.

DTC P1886:00		Configuration data not recorded
DETECTION CONDITION		• 4WD CM detects vehicle type information data error
FAIL-SAFE FUNCTION		• Control disabled. • 4WD warning light: Illuminated
POSSIBLE CAUSE		• PCM malfunction • Wrong 4WD CM is installed