DTC B10DF:46/C1A08:1C/U2007:46/U2007:62/U3000:49 [DYNAMIC STABILITY CONTROL (DSC)]


id0402b2905700

DTC
B10DF:46, C1A08:1C, U2007:46, U2007:62, U3000:49
DSC HU/CM (internal malfunction)
DETECTION CONDITION
•  The DSC CM on-board diagnostic function detects control module internal malfunction.
FAIL-SAFE FUNCTION
•  B10DF:46, U2007:46
―  Illuminates the TCS/DSC indicator light and master warning light*1.
―  Inhibits the TCS, DSC, roll over mitigation (ROM), brake assist control, vehicle roll prevention function*2, hill launch assist (HLA), smart city brake support (SCBS)*1, and secondary collision reduction (SCR) controls.
•  C1A08:1C
―  Illuminates the TCS/DSC indicator light and master warning light*1.
―  Tire pressure monitoring system warning light illuminates after flashes.
―  Inhibits the TCS, DSC, roll over mitigation (ROM), brake assist control, vehicle roll prevention function*2, hill launch assist (HLA), TPMS, smart city brake support (SCBS)*1, and secondary collision reduction (SCR) controls.
•  U2007:62
―  Illuminates the ABS warning light, brake system warning light, TCS/DSC indicator light, and master warning light*1.
―  Inhibits the ABS, EBD, TCS, DSC, roll over mitigation (ROM), brake assist control, vehicle roll prevention function*2, hill launch assist (HLA), smart city brake support (SCBS)*1, and secondary collision reduction (SCR) controls.
•  U3000:49
―  Illuminates the ABS warning light*3, brake system warning light*3, TCS/DSC indicator light, and master warning light*1.
―  Tire pressure monitoring system warning light illuminates after flashes. (Not illuminated/flashed depending on malfunction content.)
―  Inhibits the ABS*4, EBD*4, TCS, DSC, roll over mitigation (ROM), brake assist control*4, vehicle roll prevention function*2, hill launch assist (HLA), TPMS*4, smart city brake support (SCBS)*1, and secondary collision reduction (SCR) controls.
*1: Vehicles with smart city brake support (SCBS)
*2: ATX only
*3: Not illuminated depending on malfunction content.
*4: Enabled depending on malfunction content.
POSSIBLE CAUSE
•  DSC HU/CM internal malfunction
SYSTEM WIRING DIAGRAM

Diagnostic procedure

STEP

INSPECTION

ACTION

1
VERIFY NO DSC HU/CM MALFUNCTION
•  Clear the DTCs from the memory.
•  Start the engine and drive the vehicle at 10km/h {6.2 mph} or more.
•  Are the same DTCs present?
Yes
Replace the DSC HU/CM, then go to the next step.
No
Go to the next step.
2
VERIFY THAT NO OTHER DTCS ARE PRESENT
•  Are any other DTCs output?
Yes
Go to the applicable DTC inspection.
No
DTC troubleshooting completed.