DTC: B116A:13 [Bluetooth SYSTEM (HANDS-FREE TELEPHONE (HF/TEL) SYSTEM)]
id0902g8452100
Description |
Open circuit in microphone circuit |
---|---|
Detection condition
|
Microphone non-connection signal constantly detected
|
Fail-safe function
|
—
|
Possible cause
|
• Connector or terminal malfunction
• Open circuit in wiring harness between Bluetooth unit terminal B and microphone terminal B
• Short to ground in wiring harness between Bluetooth unit terminal A and microphone terminal A
• Microphone malfunction
• Bluetooth unit malfunction
|
![]() |
Diagnostic Procedure
Step |
Inspection |
Action |
|
---|---|---|---|
1
|
INSPECT MICROPHONE CONNECTOR STATUS
• Switch the ignition off (LOCK).
• Disconnect the negative battery cable.
• Disconnect the microphone connector.
• Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
• Is there any malfunctioning part?
|
Yes
|
Repair or replace the connector, then go to Step 5.
|
No
|
Go to the next step.
|
||
2
|
INSPECT BLUETOOTH UNIT CONDITION
• Disconnect the Bluetooth unit connector.
• Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
• Is there any malfunctioning part?
|
Yes
|
Repair or replace the connector, then go to Step 5.
|
No
|
Go to the next step.
|
||
3
|
INSPECT MICROPHONE CIRCUIT FOR OPEN CIRCUIT
• Inspect the wiring harness for continuity between Bluetooth unit terminal B and microphone terminal B (vehicle wiring harness side).
• Is there continuity?
|
Yes
|
Go to the next step.
|
No
|
Repair or replace the wiring harness which has an open circuit, then go to Step 5.
|
||
4
|
INSPECT FOR SHORT TO GROUND IN MICROPHONE INPUT CIRCUIT
• Inspect for continuity between Bluetooth unit terminal A (vehicle wiring harness side) and body ground.
• Is there continuity?
|
Yes
|
Repair or replace the wiring harness which has a short to ground, then go to the next step.
|
No
|
Go to the next step.
|
||
5
|
PERFORM DTC INSPECTION AND VERIFY IF MALFUNCTIONING PART IS MICROPHONE OR BLUETOOTH UNIT
• Reconnect all the disconnected connectors.
• Connect the negative battery cable.
• Perform an inspection of the Bluetooth unit DTCs.
• Is the same DTC displayed?
|
Yes
|
Replace the microphone, then go to the next step.
|
No
|
Go to Step 7.
|
||
6
|
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
• Perform an inspection of the Bluetooth unit DTCs.
• Is the same DTC displayed?
|
Yes
|
Replace the Bluetooth unit, then go to the next step.
|
No
|
Go to the next step.
|
||
7
|
VERIFY IF OTHER DTCs DISPLAYED
• Are any other DTCs displayed?
|
Yes
|
Repair the malfunctioning part according to the applicable DTC troubleshooting.
|
No
|
DTC troubleshooting completed.
|