DTC U3000:09 [BLIND SPOT MONITORING (BSM)]

id0902i3393100

System malfunction location

BSM control module internal malfunction

Detection condition

•  The BSM control module detected a malfunction inside the voltage control oscillator.

Fail-safe

•  BSM is stopped.

Possible cause

•  BSM control module malfunction

System wiring diagram

—

System malfunction location	BSM control module internal malfunction
Detection condition	• The BSM control module detected a malfunction inside the voltage control oscillator.
Fail-safe	• BSM is stopped.
Possible cause	• BSM control module malfunction
System wiring diagram	—

Diagnostic Procedure

Step	Inspection		Action
1	PERFORM DTC INSPECTION AND VERIFY IF MALFUNCTIONING PART IS BSM CONTROL MODULE • Clear BSM control module DTCs using the M-MDS. (See CLEARING DTC [BLIND SPOT MONITORING (BSM)].) • Perform the DTC inspection for the BSM control module using the M-MDS. (See DTC INSPECTION [BLIND SPOT MONITORING (BSM)].) • Is the DTC U3000:09 displayed?	Yes	Replace the BSM control module, then go to the next step. (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION.)
1		No	Go to the next step.
2	VERIFY IF OTHER DTCs DISPLAYED • Are any other DTCs displayed?	Yes	Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [BLIND SPOT MONITORING (BSM)].)
2		No	DTC troubleshooting completed.