DTC U3000:56 [FRONT BODY CONTROL MODULE (FBCM)]

id0902p2011500

System malfunction location

Front body control module (FBCM) configuration error

Detection condition

•  Front body control module (FBCM) configuration error detected.

Fail-safe

—

Possible cause

•  Front body control module (FBCM) configuration error

•  Front body control module (FBCM) malfunction

System wiring diagram

—

System malfunction location	Front body control module (FBCM) configuration error
Detection condition	• Front body control module (FBCM) configuration error detected.
Fail-safe	—
Possible cause	• Front body control module (FBCM) configuration error • Front body control module (FBCM) malfunction
System wiring diagram	—

Diagnostic Procedure

Step	Inspection		Action
1	VERIFY FRONT BODY CONTROL MODULE (FBCM) DTCs AGAIN • Clear front body control module (FBCM) DTCs using the M-MDS. (See CLEARING DTC [FRONT BODY CONTROL MODULE (FBCM)].) • Perform the front body control module (FBCM) DTC inspection using the M-MDS. (See DTC INSPECTION [FRONT BODY CONTROL MODULE (FBCM)].) • Is DTC U3000:56 displayed?	Yes	Go to the next step.
1		No	Go to Step 4.
2	PERFORM FRONT BODY CONTROL MODULE (FBCM) CONFIGURATION • Perform the front body control module (FBCM) configuration using the M-MDS. (See FRONT BODY CONTROL MODULE (FBCM) CONFIGURATION (USING AS-BUILT DATA).) • Clear front body control module (FBCM) DTCs using the M-MDS. (See CLEARING DTC [FRONT BODY CONTROL MODULE (FBCM)].) • Perform the front body control module (FBCM) DTC inspection using the M-MDS. (See DTC INSPECTION [FRONT BODY CONTROL MODULE (FBCM)].) • Is DTC U3000:56 displayed?	Yes	Using the M-MDS, re-perform the front body control module (FBCM) configuration, then go to the next step. (See FRONT BODY CONTROL MODULE (FBCM) CONFIGURATION (USING AS-BUILT DATA).)
2		No	Go to Step 4.
3	VERIFY THAT REPAIRS HAVE BEEN COMPLETED • Clear front body control module (FBCM) DTCs using the M-MDS. (See CLEARING DTC [FRONT BODY CONTROL MODULE (FBCM)].) • Perform the front body control module (FBCM) DTC inspection using the M-MDS. (See DTC INSPECTION [FRONT BODY CONTROL MODULE (FBCM)].) • Is DTC U3000:56 displayed?	Yes	replace the front body control module (FBCM), then go to the next step. (See FRONT BODY CONTROL MODULE (FBCM) REMOVAL/INSTALLATION.)
3		No	Go to the next step.
4	VERIFY IF OTHER DTCs DISPLAYED • Are any other DTCs displayed?	Yes	Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [FRONT BODY CONTROL MODULE (FBCM)].)
4		No	DTC troubleshooting completed.