DTC B13D3:97 [START STOP UNIT]

id0902p6020900

System malfunction location

Remote transmitter registration work not completed

Detection condition

•  The start stop unit detects that the registration of a remote transmitter has not been completed.

Fail-safe

—

Possible cause

•  DTCs are stored in the immobilizer system.

•  Start stop unit configuration error

•  Remote transmitter registration not completed correctly.

•  Start stop unit malfunction

System wiring diagram

—

System malfunction location	Remote transmitter registration work not completed
Detection condition	• The start stop unit detects that the registration of a remote transmitter has not been completed.
Fail-safe	—
Possible cause	• DTCs are stored in the immobilizer system. • Start stop unit configuration error • Remote transmitter registration not completed correctly. • Start stop unit malfunction
System wiring diagram	—

Diagnostic Procedure

Step	Inspection		Action
1	VERIFY IMMOBILIZER SYSTEM DTCs • Perform the DTC inspection for the immobilizer system using the M-MDS. (See DTC INSPECTION [IMMOBILIZER SYSTEM].) • Is the DTC displayed?	Yes	Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC INSPECTION [IMMOBILIZER SYSTEM].)
1		No	Go to the next step.
2	PERFORM START STOP UNIT CONFIGURATION (USING AS-BUILT DATA) • Using the M-MDS, perform the start stop unit configuration with the As-Built data. (See START STOP UNIT CONFIGURATION (USING AS-BUILT DATA).) • Clear DTC for the start stop unit using the M-MDS. (See CLEARING DTC [START STOP UNIT].) • Perform the DTC inspection for the start stop unit using the M-MDS. (See DTC INSPECTION [START STOP UNIT].) • Is DTC B13D3:97 displayed?	Yes	Using the M-MDS, re-perform the start stop unit configuration using the As-Built data, then go to the next step. (See START STOP UNIT CONFIGURATION (USING AS-BUILT DATA).)
2		No	Go to Step 5.
3	REGISTER REMOTE TRANSMITTER • Register the remote transmitter. (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING.) • Clear DTC for the start stop unit using the M-MDS. (See CLEARING DTC [START STOP UNIT].) • Perform the DTC inspection for the start stop unit using the M-MDS. (See DTC INSPECTION [START STOP UNIT].) • Is DTC B13D3:97 displayed?	Yes	Go to the next step.
3		No	Go to Step 5.
4	VERIFY THAT REPAIRS HAVE BEEN COMPLETED • Clear DTC for the start stop unit using the M-MDS. (See CLEARING DTC [START STOP UNIT].) • Perform the DTC inspection for the start stop unit using the M-MDS. (See DTC INSPECTION [START STOP UNIT].) • Is DTC B13D3:97 displayed?	Yes	Replace the start stop unit, then go to the next step. (See START STOP UNIT REMOVAL/INSTALLATION.)
4		No	Go to the next step.
5	VERIFY IF OTHER DTCs DISPLAYED • Are any other DTCs displayed?	Yes	Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [START STOP UNIT].)
5		No	DTC troubleshooting completed.