DTC U2100:00 [START STOP UNIT]


id0902p6024500

System malfunction location

Start stop unit configuration not completed

Detection condition
•  Start stop unit configuration not completed.
Fail-safe
•  Although the engine cannot be started with the ignition switched OFF (LOCK) or to ACC, if the ignition is switched ON (engine off), the engine can be started.
Note
•  If the start stop unit configuration is not completed, the start stop unit setting will be for an ATX vehicle.
•  For MTX vehicles, if the start stop unit cannot receive the CAN signal, the engine cannot be started because the vehicle cannot be recognized as a MTX vehicle.
Possible cause
•  Start stop unit configuration error
•  Start stop unit malfunction
System wiring diagram

Diagnostic Procedure

Step

Inspection

Action

1
PERFORM START STOP UNIT CONFIGURATION
•  Perform the start stop unit configuration using the M-MDS.
•  Clear DTC for the start stop unit using the M-MDS.
•  Perform the DTC inspection for the start stop unit using the M-MDS.
•  Is DTC U2100:00 displayed?
Yes
Perform the start stop unit configuration again, then go to the next step.
No
Go to Step 3.
2
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
•  Clear DTC for the start stop unit using the M-MDS.
•  Perform the DTC inspection for the start stop unit using the M-MDS.
•  Is DTC U2100:00 displayed?
Yes
Replace the start stop unit, then go to the next step.
No
Go to the next step.
3
VERIFY IF OTHER DTCs DISPLAYED
•  Are any other DTCs displayed?
Yes
Repair the malfunctioning part according to the applicable DTC troubleshooting.
No
DTC troubleshooting completed.