DTC U3000:96 [START STOP UNIT]

id0902p6050000

System malfunction location

Start stop unit malfunction

Detection condition

•  Start stop unit malfunction detected.

Fail-safe

•  Cancel the i-stop control. (With i-stop)

Possible cause

•  Start stop unit malfunction

System wiring diagram

—

System malfunction location	Start stop unit malfunction
Detection condition	• Start stop unit malfunction detected.
Fail-safe	• Cancel the i-stop control. (With i-stop)
Possible cause	• Start stop unit malfunction
System wiring diagram	—

Diagnostic Procedure

Step	Inspection		Action
1	PERFORM DTC INSPECTION AND VERIFY IF MALFUNCTIONING PART IS START STOP UNIT • Clear DTC for the start stop unit using the M-MDS. (See CLEARING DTC [START STOP UNIT].) • Perform the DTC inspection for the start stop unit using the M-MDS. (See DTC INSPECTION [START STOP UNIT].) • Is DTC U3000:96 displayed?	Yes	Replace the start stop unit, then go to the next step. (See START STOP UNIT REMOVAL/INSTALLATION.)
1		No	Go to the next step.
2	VERIFY IF OTHER DTCs DISPLAYED • Are any other DTCs displayed?	Yes	Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [START STOP UNIT].)
2		No	DTC troubleshooting completed.