DTC U3000:54 [REAR VEHICLE MONITORING SYSTEM]
id0902z2569200
System malfunction location |
Radar aiming is not performed or radar sensor axis is deviated (rear vehicle monitoring control module (RH)) |
---|---|
Detection condition
|
• Malfunction in radar aiming of rear vehicle monitoring control module (RH) detected for 1 s or more.
|
Fail-safe
|
• Inhibits the rear vehicle monitoring system.
|
Possible cause
|
• Rear vehicle monitoring control module (RH) radar aiming was not performed.
• Deviation of rear vehicle monitoring control module (RH) radar sensor axis
• Rear vehicle monitoring control module (RH) malfunction
|
System wiring diagram
|
—
|
Diagnostic Procedure
Step |
Inspection |
Action |
|
---|---|---|---|
1
|
PERFORM REAR VEHICLE MONITORING CONTROL MODULE (RH) RADAR AIMING
• Perform the rear vehicle monitoring control module (RH) radar aiming.
• Clear the DTC for the rear vehicle monitoring control module using the M-MDS.
• Switch the ignition ON (engine off or on) and wait for 1.5 s or more.
• Perform the DTC inspection for the rear vehicle monitoring control module using the M-MDS.
• Is DTC U3000:54 displayed?
|
Yes
|
Perform the rear vehicle monitoring control module (RH) radar aiming again, then go to the next step.
|
No
|
Go to Step 3.
|
||
2
|
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
• Clear the DTC for the rear vehicle monitoring control module using the M-MDS.
• Switch the ignition ON (engine off or on) and wait for 1.5 s or more.
• Perform the DTC inspection for the rear vehicle monitoring control module using the M-MDS.
• Is DTC U3000:54 displayed?
|
Yes
|
Replace the rear vehicle monitoring control module (RH), then go to the next step.
|
No
|
Go to the next step.
|
||
3
|
VERIFY IF OTHER DTCs DISPLAYED
• Are any other DTCs displayed?
|
Yes
|
Repair the malfunctioning part according to the applicable DTC troubleshooting.
|
No
|
DTC troubleshooting completed.
|