AUDIO UNIT PERSONALIZATION FEATURES SETTING PROCEDURE


id092000000200


Door Locks Systems

1.  Switch the ignition ON (engine off or on).

2.  Turn the audio unit power on.

3.  Select the following from the audio unit screen.

(1)  “Setup”
(2)  “Vehicle”
(3)  “Door Locks“

4.  Select the following items and change the setting.


Advanced keyless entry system

Audio unit display

Function

Initial setting

Settings

Control module

Auto Re-lock Time
The operation start time of the auto re-lock function can be changed.
30 seconds
30 seconds / 60 seconds / 90 seconds
Start stop unit
Lock Beep Volume
The keyless beeper volume can be adjusted.
Medium
Off / Low / Medium / High
Start stop unit
Walk Away Lock
The out-of-area (reception area) type auto lock function can be set.
OFF
OFF / ON
Start stop unit


Keyless entry system

Audio unit display

Function

Initial setting

Settings

Control module

Auto Re-lock Time
The operation start time of the auto re-lock function can be changed.
30 seconds
30 seconds / 60 seconds / 90 seconds
Start stop unit


Lighting Systems

1.  Switch the ignition ON (engine off or on).

2.  Turn the audio unit power on.

3.  Select the following from the audio unit screen.

(1)  “Setup”
(2)  “Vehicle”
(3)  “Lighting“

4.  Select the following items and change the setting.


High beam control (HBC) system

Audio unit display

Function

Initial setting

Settings

Control module

High Beam Control
The high beam control (HBC) system can be switched between operable and inoperable.
On
On / Off
FSC


Turn light system

Audio unit display

Function

Initial setting

Settings

Control module

3-Flash Turn Signal
The turn light system can be switched between operable and inoperable.
On
On / Off
Rear body control module (RBCM)


Auto light system

Audio unit display

Function

Initial setting

Settings

Control module

Auto-headlight On
Auto light sensor sensitivity can be changed.
Medium
Light / Medium Light / Medium / Medium Dark / Dark
Rear body control module (RBCM)

Note
•  If the mode is set to “Light” and “Medium Light”, the illumination level for illuminating the TNS and headlight increases. Therefore, the TNS and headlights illuminate when the ambient light is brighter than when the level is set to “Medium”. In addition, if the mode is set to “Medium Dark” and “Dark”, the illumination level for illuminating the TNS and headlights decreases. Therefore, the TNS and headlights illuminate when the ambient light is lower than when the level is set to “Medium”.


Room light control system

Audio unit display

Function

Initial setting

Settings

Control module

Interior Light Timeout - Door Open
The front/rear map light illumination time after any door is open can be changed.
30 minutes
60 minutes / 30 minutes / 10 minutes
Rear body control module (RBCM)
Interior Light Timeout - Door Closed
The front/rear map light illumination time after any door is closed can be changed.
15 seconds
60 seconds / 30 seconds / 15 seconds / 7.5 seconds
Rear body control module (RBCM)


Wiper Systems

1.  Switch the ignition ON (engine off or on).

2.  Turn the audio unit power on.

3.  Select the following from the audio unit screen.

(1)  “Setup”
(2)  “Vehicle”

4.  Select the following items and change the setting.


Auto wiper system

Audio unit display

Function

Initial setting

Settings

Control module

Wipers
The auto wiper function can be disabled.
On (Rain Sensing)
On (Rain Sensing) / Off*1 (Intermittent)
Rear body control module (RBCM)

*1  :If the function is set to “Off”, the wipers will operate intermittently with the wiper switch in AUTO position.