STARTER INSPECTION [SKYACTIV-D 2.2]

id0119h8800300

On-vehicle Inspection

1.  Verify that the battery is fully charged. (See BATTERY RECHARGING.)

2.  The starter is normal if it rotates smoothly and without any noise when the engine is cranked.

•  If the starter does not operate, inspect the following:

―  Remove the starter, and inspect the starter unit. (See STARTER REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

―  Inspect the related wiring harnesses, the ignition switch, and the transaxle range switch (ATX) or starter interlock switch (MTX).

No-load Test

1.  Verify that the battery is fully charged. (See BATTERY RECHARGING.)

2.  Connect the starter, battery, and a tester as shown in the figure.

am6xuw00002343

3.  Operate the starter and verify that it rotates smoothly.

•  If the starter does not rotate smoothly, inspect the starter unit.

4.  Measure the voltage and current while the starter is operating.

•  If not within specification, replace the starter. (See STARTER REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)