POWER BRAKE UNIT VACUUM SENSOR INSPECTION [SKYACTIV-G 2.5T]

id0140h0889400


Function Inspection

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off).

3.  Display the PID BBP. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)].) (See PCM INSPECTION [SKYACTIV-G 2.5T].)

4.  Compare the voltage and power brake unit vacuum indications for the PID BBP with the standard in the table indicated below.

•  If they do not match the standard, replace the PCM. (See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.5T].)
•  If they match the standard, perform the voltage inspection. (See Voltage Inspection.)

Standard

BBP

V

kPa {kgf/cm2, psi}
Approx. 1.0
13.3 {0.136, 1.93}
Approx. 3.6
100.0 {1.020, 14.50}
Approx. 4.2
120.0 {1.224, 17.40}


Voltage Inspection

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off).

3.  Verify that the power brake unit vacuum sensor output voltage (PID: BBP) is within the specification. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)].) (See PCM INSPECTION [SKYACTIV-G 2.5T].)

•  If not within the specification, replace the power brake unit vacuum sensor. (See POWER BRAKE UNIT VACUUM SENSOR REMOVAL/INSTALLATION [L.H.D.].) (See POWER BRAKE UNIT VACUUM SENSOR REMOVAL/INSTALLATION [R.H.D.].)

Specification

ac5wzw00009761