UREA TEMPERATURE SENSOR INSPECTION [SKYACTIV-D 2.2]

id0140z7826800

Note

•  If measurements are taken with the vehicle on an uneven surface, a correct urea level cannot be detected because the urea tank could be tilted. When inspecting, take measurements with the vehicle on level ground.

•  If the ambient temperature is low, the AdBlue^® may have frozen and the AdBlue^® level may not have been detected correctly. If the ambient temperature level is below freezing, take the measurement after the AdBlue^® has defrosted.

PID/DATA Monitor Inspection

1.  Park the vehicle on level ground.

2.  Verify the ambient temperature.

Ambient temperature is below freezing

•  After warming up the engine for approx.1 hour, go to the next step.

Ambient temperature is above freezing

•  Go to the next step.

3.  Connect the M-MDS to the DLC-2.

4.  Switch the ignition ON (engine off).

5.  Using the M-MDS, display the urea temperature (PID: S_UR_TANK_TMP) detected by the urea temperature sensor and the urea temperature detected by the urea quality sensor (PID: DEF_T) (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-D 2.2)].) (See ON-BOARD DIAGNOSTIC TEST [DOSING CONTROL UNIT (SKYACTIV-D 2.2)].)

6.  Verify that the difference in values between PID S_UR_TANK_TMP and PID DEF_T is within ±6 °C.

•  If the output value is out of the range, replace the urea tank. (See UREA TANK REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)