REAR WHEEL HUB BOLT REPLACEMENT

id031200800200

Special Service Tool (SST)

49 T028 3A0   Ball joint puller set

1.  Switch the ignition ON (engine off).

2.  Release the electric parking brake.

3.  Switch the ignition off.

4.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

5.  Remove the wheel and tire. (See WHEEL AND TIRE REMOVAL/INSTALLATION.)

6.  Disconnect the electric parking brake motor gear unit connector. (See ELECTRIC PARKING BRAKE MOTOR GEAR UNIT REMOVAL/INSTALLATION.)

7.  Remove the rear brake caliper component and suspend it out of the way using a cable. (See REAR BRAKE DISC REMOVAL/INSTALLATION.)

ac9uuw00008034

8.  Remove the rear disc plate. (See REAR BRAKE DISC REMOVAL/INSTALLATION.)

9.  Remove the wheel hub bolt using the SST as shown in the figure.

ac5jjw00003212

10.  Place a new wheel hub bolt in the wheel hub.

11.  Install the wheel hub by placing a proper sized washer on the hub, and tightening the nut as shown in the figure.

am3uuw00006182