AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [GW6A-EL, GW6AX-EL]

id0517i2118600

Replacement Part

Washer
 
Quantity: 1
 
Location of use: Drain plug

Oil and Chemical Type

ATF
 
Type: ATF FZ

Warning
•  Do not perform the servicing while the ATF is hot. Otherwise, it could cause severe burns or serious injury.

1.  Remove the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

2.  Disconnect the oil pipe No.1 from the wiring harness bracket with the oil hose connected. (With oil cooler No.2)

ac5wzw00011200

3.  Remove the dipstick securing bolt.

ac5wzw00003607

4.  Remove the dipstick.

5.  Remove the drain plug and washer, and drain the ATF.

am3zzw00012640

6.  Install a new washer and drain plug.

Tightening torque
30—41 N·m {3.1—4.1 kgf·m, 23—30 ft·lbf}

7.  Add ATF from the dipstick installation hole.

Note
•  The ATF color is blue.
•  Only use ATF FZ for the GW6A-EL, GW6AX-EL.

ATF type

Resupply amount (Reference)
ATF FZ
ATF is drained from drain plug: 3.5—4.9 L {3.7—5.1 US qt, 3.1—4.3 Imp qt}

8.  Adjust the ATF level. (See AUTOMATIC TRANSAXLE FLUID (ATF) ADJUSTMENT [GW6A-EL, GW6AX-EL].)

9.  Insert the dipstick and install the securing bolt.

ac5wzw00003607

Tightening torque
8—11 N·m {82—112 kgf·cm, 71—97 in·lbf}

10.  Install the oil pipe No.1 to the wiring harness bracket. (With oil cooler No.2)

ac5wzw00003747

11.  Install the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)