EVAPORATOR TEMPERATURE SENSOR INSPECTION [MANUAL AIR CONDITIONER]

id0740a2801200

Note

•  Inspect the evaporator temperature sensor when it is installed to the A/C unit.

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

(2)  Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION.)

3.  Connect the negative battery terminal.

4.  Switch the ignition ON (engine on).

5.  Set the fan speed to MAX HI.

6.  Set the temperature control to MAX COLD.

7.  Set to the RECIRCULATE mode.

8.  Turn the A/C switch off.

9.  Close all doors and windows.

10.  Wait for 5 min.

11.  Switch the ignition off.

12.  Disconnect the negative battery terminal.

13.  Disconnect the evaporator temperature sensor connector. (See EVAPORATOR TEMPERATURE SENSOR REMOVAL/INSTALLATION [MANUAL AIR CONDITIONER].)

14.  Measure the temperature at the blower inlet.

15.  Measure the resistance between the evaporator temperature sensor terminals A and B.

ac5jjw00008814

•  If the resistance is not as shown in the graph, replace the evaporator temperature sensor. (See EVAPORATOR TEMPERATURE SENSOR REMOVAL/INSTALLATION [MANUAL AIR CONDITIONER].)

am3uuw00004032