PID/DATA MONITOR TABLE [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)]
id0802g8081000
PID |
Unit/Condition |
Data contents |
SAS control module terminal |
|
---|---|---|---|---|
AB_WL
(Air bag system warning light status)
|
Lamp_Off/Lamp_On/Plant_Mode/Unknown
|
• Air bag system warning light off: Lamp_Off
• Air bag system warning light on: Lamp_On
• Air bag system warning light flashing: Plant_Mode
• Air bag system warning light unrecognized: Unknown
|
3Q, 3S
|
|
PCD_A
(Poorly connected detector bar terminal voltage nominal (SAS control module connector A))
|
V
|
• Normal connected: 270.9 mV or less
• Poor connected: 3173.4 mV or more
|
1a, 1b
|
|
PCD_B
(Poorly connected detector bar terminal voltage nominal (SAS control module connector B))
|
V
|
• Normal connected: 270.9 mV or less
• Poor connected: 3173.4 mV or more
|
2a, 2b
|
|
PCD_C
(Poorly connected detector bar terminal voltage nominal (SAS control module connector C))
|
V
|
• Normal connected: 270.9 mV or less
• Poor connected: 3173.4 mV or more
|
3a, 3b
|
|
RES_C_AB_D
(Driver-side curtain air bag module resistance nominal)
|
ohm
|
Continuous: 0.88–6.33 ohms
|
1U, 1W
|
|
RES_C_AB_P
(Passenger-side curtain air bag module resistance nominal)
|
ohm
|
Continuous: 0.88–6.33 ohms
|
1Z, 1AA
|
|
RES_F_AB1_D
(Driver-side air bag module (inflatorNo.1) resistance nominal)
|
ohm
|
Continuous: 1.37–6.33 ohms
|
3C, 3G
|
|
RES_F_AB1_P
(Passenger-side air bag module (inflatorNo.1) resistance nominal)
|
ohm
|
Continuous: 0.88–6.33 ohms
|
3K, 3N
|
|
RES_R_PR_D
(Driver-side rear pre-tensioner seat belt status)
|
ohm
|
Continuous: 0.88–6.33 ohms
|
1AB, 1AD
|
|
RES_R_PR_P
(Passenger-side rear pre-tensioner seat belt status)
|
ohm
|
Continuous: 0.88–6.33 ohms
|
1S, 1X
|
|
RES_S_AB_D
(Driver-side side air bag module resistance nominal)
|
ohm
|
Continuous: 0.88–10.53 ohms
|
1G, 1C
|
|
RES_S_AB_P
(Passenger-side side air bag module resistance nominal)
|
ohm
|
Continuous: 0.88–10.53 ohms
|
1K, 1N
|
|
RES_SB_LP_D
(Driver-side lap pre-tensioner seat belt resistance nominal)
|
|
|||
RES_SB_P_D
(Driver-side front pre-tensioner seat belt resistance nominal)
|
ohm
|
Continuous: 0.88–6.33 ohms
|
2G, 2C
|
|
RES_SB_P_P
(Passenger-side front pre-tensioner seat belt resistance nominal)
|
ohm
|
Continuous: 0.88–6.33 ohms
|
2K, 2N
|
|
SEAT_B_D
(Driver-side buckle switch status)
|
Unbuckled/Buckled
|
• Driver-side front seat belt fastened (Driver-side buckle switch off): Buckled
• Driver-side front seat belt not fastened (Driver-side buckle switch on): Unbuckled
|
2U
|
|
SEAT_B_P
(Passenger-side buckle switch status)
|
Unbuckled/Buckled
|
• Passenger-side front seat belt fastened (Passenger-side buckle switch off): Buckled
• Passenger-side front seat belt not fastened (Passenger-side buckle switch on): Unbuckled
|
2W
|
|
VPWR_IGA
(SAS control module power voltage)
|
V
|
Ignition is switched ON: IG1 voltage
|
2AD
|