POWER LIFTGATE (PLG) REAR SWITCH REMOVAL/INSTALLATION

id091100807500

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Insert a remover tool into the service hole, move it in the direction of the arrow shown in the figure, and remove the cover No.1.

ac5wzw00014210

3.  Insert your hand from the cover No.1 installation hole, and remove the power liftgate (PLG) rear switch in the direction of the arrow shown in the figure while detaching the tabs from the liftgate lower trim.

ac5wzw00014211

4.  Disconnect the power liftgate (PLG) rear switch connector.

5.  Install in the reverse order of removal.