DTC C0061:28/C0061:64/C0062:28/C0062:64/C0063:28/C0063:64 [DYNAMIC STABILITY CONTROL (DSC)]


id0402b2180800

DTC
C0061:28, C0061:64, C0062:28, C0062:64, C0063:28, C0063:64
SAS control module system
DETECTION CONDITION
Note
•  The low-G sensor and the yaw rate sensor are built into the SAS control module.
•  C0061:28, C0061:64
―  Out-of-specification signal modulation or lateral-G value is detected from the low-G sensor.
•  C0062:28, C0062:64
―  Out-of-specification signal modulation or longitudinal-G value is detected from the low-G sensor.
•  C0063:28, C0063:64
―  Out-of-specification signal modulation or yaw rate value is detected from the yaw rate sensor.
FAIL-SAFE FUNCTION
Refer to “DTC Table” and “Fail-safe Function Malfunction Contents”. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)].)
POSSIBLE CAUSE
•  SAS control module malfunction
•  DSC HU/CM malfunction
•  Poor connection at connectors (female terminal)
SYSTEM WIRING DIAGRAM

Diagnostic procedure

STEP

INSPECTION

ACTION

1
INSPECT SAS CONTROL MODULE MALFUNCTION
•  Switch the ignition to off.
•  Using the M-MDS, perform the DTC inspection for the SAS control module.
•  Are any DTCs detected?
Yes
Go to applicable DTC inspection.
No
Go to the next step.
2
VERIFY THAT THE SAME DTC IS NOT PRESENT
•  Reconnect all disconnected connectors.
•  Clear the DTCs from the memory.
•  Start the engine and drive the vehicle at 10 km/h {6.2 mph} or more.
•  Are the same DTCs present?
Yes
Repeat the inspection from Step 1.
If the malfunction recurs, replace the DSC HU/CM, then go to the next step.
No
Go to the next step.
3
VERIFY THAT NO OTHER DTCS ARE PRESENT
•  Are any other DTCs output?
Yes
Go to the applicable DTC inspection.
No
DTC troubleshooting completed.