DTC U0515:00 [DYNAMIC STABILITY CONTROL (DSC)]
id0402b2892500
|
DTC
|
U0515:00
|
Abnormal signal from cruise control switches
|
|
|
DETECTION CONDITION
|
• The DSC HU/CM received error signals from the cruise control switches with the ignition switched ON (engine off or on).
|
||
|
FAIL-SAFE FUNCTION
|
Refer to “DTC Table” and “Fail-safe Function Malfunction Contents”. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)].)
|
||
|
POSSIBLE CAUSE
|
• Cruise control switch malfunction
• Start stop unit malfunction
|
||
|
SYSTEM WIRING DIAGRAM
|
—
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
INSPECT CRUISE CONTROL SWITCH
• Inspect the cruise control switch.
• Is the cruise control normal?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the cruise control switch, then go to the next step.
|
||
|
2
|
PERFORM START STOP UNIT DTC INSPECTION
• Switch the ignition to off.
• Verify DTCs for the start stop unit using the M-MDS.
• Is the DTC displayed?
|
Yes
|
Go to applicable DTC inspection.
(See DTC TABLE [START STOP UNIT].)
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY THAT THE SAME DTC IS NOT PRESENT
• Clear DTC for the DSC HU/CM using the M-MDS.
• Are the same DTCs present?
|
Yes
|
Repeat the inspection from Step 1.
If the malfunction recurs, replace the start stop unit, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY THAT NO OTHER DTCS ARE PRESENT
• Are any other DTCs output?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||