NO.7 TCS/DSC INDICATOR LIGHT FLASHES (WHEN NEITHER THE TCS NOR THE DSC ARE OPERATING) [DYNAMIC STABILITY CONTROL (DSC)]
id0403b2896200
7 |
TCS/DSC indicator light flashes (when neither the TCS nor the DSC are operating) |
---|---|
POSSIBLE CAUSE
|
• Non-completion of DSC related parts sensor initialization. (If the initialization is not carried out after replacing the DSC HU/CM and/or SAS control module, a TCS/DSC indicator light will flash. In this case, the DSC is not detected.)
|
Diagnostic procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
INSPECT CONNECTION OF DSC HU/CM AND SAS CONTROL MODULE CONNECTORS
• Inspect for connection of DSC HU/CM and SAS control module (yaw rate sensor, low-G sensor) connectors.
• Are DSC HU/CM and SAS control module connectors connected securely?
|
Yes
|
Perform the initialization procedure.
|
No
|
Perform the initialization procedure after connect the suspected connector securely.
|