DTC U2005:86 [INSTRUMENT CLUSTER]

id0902e8509800

System malfunction location

Error signal received from PCM
Detection condition
•  The instrument cluster receives vehicle speed signal error from the PCM for 1 s or more with the ignition switched ON (engine off or on).
Fail-safe
—
Possible cause
•  DTCs are stored in the PCM.
•  Instrument cluster malfunction
System wiring diagram
—

Diagnostic Procedure

Step

Inspection

Action
1
VERIFY INSTRUMENT CLUSTER DTCs
•  Perform the DTC inspection for the instrument cluster using the M-MDS.
•  Is the DTC displayed?
Yes
Repair the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [INSTRUMENT CLUSTER].)
No
Go to the next step.
2
VERIFY PCM DTCs
•  Perform the DTC inspection for the PCM using the M-MDS.
•  Is the DTC displayed?
Yes
Repair the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [SKYACTIV-G 2.0, SKYACTIV-G 2.5].)
(See DTC TABLE [SKYACTIV-D 2.2].)
No
Go to the next step.
3
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
•  Clear DTC for the instrument cluster using the M-MDS.
•  Switch the ignition ON (engine off or on) and wait for 20 s or more.
•  Perform the DTC inspection for the instrument cluster using the M-MDS.
•  Is the DTC U2005:86 displayed?
Yes
Replace the instrument cluster, then go to the next step.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
No
Go to the next step.
4
VERIFY IF OTHER DTCs DISPLAYED
•  Are any other DTCs displayed?
Yes
Repair the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [INSTRUMENT CLUSTER].)
No
DTC troubleshooting completed.