MRCC WARNING LIGHT (AMBER) IS NOT ILLUMINATED [RADAR UNIT]

id1503a1010300

Description

Possible malfunction

Note

•  The detection performance of the radar unit has limitations and the mazda radar cruise control (MRCC) system may not operate normally. For the detection performance limitations, refer to the [RADAR UNIT] in the technical guide.

―  Instrument cluster malfunction (malfunction in MRCC warning light (amber) illumination circuit)

―  Connector connection malfunction

―  Connector connection malfunction

―  Radar unit malfunction

Diagnostic Procedure

Step	Inspection		Action
1	INSPECT INSTRUMENT CLUSTER •  Turn off the MRCC warning light (amber) using the M-MDS instrument cluster active command modes WL+IL. (See ACTIVE COMMAND MODES INSPECTION [INSTRUMENT CLUSTER].) •  Are all the warning lights turned on/off?	Yes	Go to the next step.
		No	Replace the instrument cluster. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
2	VERIFY INSTRUMENT CLUSTER CONNECTOR CONDITION •  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) •  Disconnect the instrument cluster connector. •  Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection. •  Is the connector normal?	Yes	Go to the next step.
		No	Repair or replace the connector.
3	VERIFY RADAR UNIT CONNECTOR CONDITION •  Disconnect the radar unit connector. •  Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection. •  Is the connector normal?	Yes	Go to the next step.
		No	Repair or replace the connector.
4	INSPECT RADAR UNIT •  Inspect the radar unit. (See RADAR UNIT INSPECTION.) •  Is the radar unit normal?	Yes	Symptom troubleshooting is completed.
		No	Replace the radar unit. (See RADAR UNIT REMOVAL/INSTALLATION.)