i-stop WARNING LIGHT (AMBER) [SKYACTIV-G 2.5T]

id0140h0008700

Purpose, Function

• If the i-stop control inhibits the operation, the i-stop warning light (amber) flashes/illuminates to inform the driver that the i-stop control inhibits the operation.

Construction

• The i-stop warning light (amber) is built into the instrument cluster. (See INSTRUMENT CLUSTER.)

• For vehicles with center display, a warning message in the center display is displayed when the i-stop warning light (amber) is illuminated or flashes. For the message content and verification method, refer to the CENTER DISPLAY in the "workshop manual".

ion

• The flashing/illumination conditions of the i-stop warning light (amber) are as follows:

i-stop warning light (amber) flashing condition

― Any of the following DTCs are stored:

PCM DTC

• For details on DTCs, refer to “ON-BOARD DIAGNOSTIC SYSTEM TEST MODE” in the “workshop manual”.

TCM DTC

• For details on DTCs, refer to “ON-BOARD DIAGNOSTIC SYSTEM MALFUNCTION DETECTION FUNCTION” in the “workshop manual”.

DSC HU/CM DTC

• For details on DTCs, refer to “ON-BOARD DIAGNOSTIC SYSTEM” in the “workshop manual”.

EPS control module DTC

• For details on DTCs, refer to “ON-BOARD DIAGNOSTIC SYSTEM” in the “workshop manual”.

i-stop warning light (amber) illumination condition

― Any one of the following conditions is met:

• Ignition switched ON (check of i-stop control system)

• i-stop OFF switch is on

• Engine stalls due to driver's operation while engine is stopped by i-stop control

• Communication error to PCM and instrument cluster

― Any of the following DTCs are stored:

PCM DTC

• For details on DTCs, refer to “ON-BOARD DIAGNOSTIC SYSTEM TEST MODE” in the “workshop manual”.

• The PCM sends an i-stop warning light (amber) flashing/illumination request to the instrument cluster via CAN communication.