SIMULATION INSPECTION

id990200000600

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off or on).

3.  Perform the following procedure using the M-MDS.

(1)  Press [Start] for the vehicle identification.

(2)  Press the [Toolbox] tab.

(3)  Press the [Diagnosis] icon.

(4)  Press [Run] for Data Logger.

4.  Select the applicable module.

5.  Select the applicable simulation item.

Note

•  The simulation function can only be implemented on items displaying the following icon.

aaxjjw00026461

6.  Inspect the operation of each part according to the directions on the screen.

Note

•  If the operation of the output part cannot be verified as a result of implementing the simulation function, an open/short circuit, sticking, or operation malfunction with the output part can be considered.