id011000502800

Caution

• The piston, piston pin and connecting rod (semi-floating type piston pin) cannot be disassembled.

• When replacing the piston, piston pin, snap ring and connecting rod (semi-floating type piston pin), replace them together as a single unit.

1.Install the connecting rod cap. (See CYLINDER BLOCK ASSEMBLY (I).)

2.Measure the connecting rod large end side clearance.

belhue00000056

Semi-floating type piston pin

• If it exceeds the specification, replace the piston, piston pin, piston ring and connecting rod as a single unit.

Full floating type piston pin

• If it exceeds the specification, replace the piston, piston pin, snap ring and connecting rod.

Connecting rod side clearance (Standard)

0.14—0.36 mm {0.0056—0.0141 in}

Connecting rod side clearance (Maximum)

0.435 mm {0.0172 in}

3.Remove the connecting rod cap.

4.Position plastigage atop the journals in the axial direction.

5.Install the connecting rod bearing and connecting rod cap. (See CYLINDER BLOCK ASSEMBLY (I).)

6.Remove the connecting rod cap.

7.Measure the connecting rod oil clearance.

belhue00000057

• If it exceeds the specification, replace the connecting rod bearing or grind the crank pin and use oversize bearings so that the specified clearance is obtained.

Connecting rod bearing oil clearance (Standard)

0.026—0.052 mm {0.0011—0.0020 in}

Connecting rod bearing oil clearance (Maximum)

0.1 mm {0.0039 in}

Connecting rod bearing size [LF]

STD: 1.498—1.522 mm {0.05863—0.05992 in}

OS0.25: 1.623—1.629 mm {0.06390—0.06413 in}

OS0.50: 1.748—1.754 mm {0.06882—0.06905 in}

Connecting rod bearing size [L3]

STD: 1.496—1.520 mm {0.05890—0.05984 in}

OS0.25: 1.621—1.627 mm {0.06382—0.06405 in}

OS0.50: 1.746—1.752 mm {0.06875—0.06897 in}

Caution

• If a malfunction is found during the Piston and connecting rod oscillation torque for the full floating type piston pin, inspect the inner diameter of the connecting rod at the small end.

8.Measure the connecting rod small end using a caliper gauge.

adj2224e254

• If not exceeds the specification, replace the connecting rod.

Standard inner diameter

LF (Full floating type piston pin): 20.935—20.946 mm {0.82422—0.82464 in}

9.Calculate the clearance between the connecting rod small end inner diameter and the new piston pin outer diameter.

• If not exceeds the specification, replace the connecting rod.

Standard clearance

0.010—0.026 mm {0.0004—0.0010 in}