id011000504100

1.Assemble in the order indicated in the table.

belhue00000166

Rear Oil Seal Assembly Note

1.Apply clean engine oil to the new oil seal lip.

2.Install the SST to the non-woven fabric side of the rear oil seal.

belhue00000086

3.From the back side of the rear oil seal, verify that there is no damage or separation in the lip area of the rear oil seal.

belhue00000087

4.Install the rear oil seal to the engine as shown in the figure.

5.Tighten the rear oil seal bolts in the order as shown in the figure.

belhue00000088

Tightening torque

8.0—11.5 N·m {81.6—117.2 kgf·cm, 70.9—101.7 in·lbf}

Drive Plate (ATX), Flywheel (MTX) Assembly Note

1.Hold the crankshaft using the SST.

2.Tighten the bolts in the 3 steps in the figure.

belhue00000089

Tightening torque

(1) 46—54 N·m {4.70—5.50 kgf·m, 34.0—39.8 ft·lbf}

(2) 76—84 N·m {7.75—8.56 kgf·m, 56.1—61.9 ft·lbf}

(3) 108—116 N·m {11.1—11.8 kgf·m, 79.7—85.5 ft·lbf}

Gasket Assembly Note

1.Apply engine oil to a new gasket.

Caution

• Assemble the gasket to the correct position using the following procedure so that the gasket lip does not overlap the oil passage for the oil cooler. Otherwise, it could leak engine oil and damage the engine.

2.Align the gasket lip to the gasket positioning areas of the oil cooler and assemble the gasket to the oil cooler.

am5uuw00002988

Oil Cooler Type B Assembly Note

1.Align one of the positioning tabs on the oil cooler as shown in the figure to the oil filter adapter hole, and install the oil cooler.

Both pipes pointed above oil cooler

amxuuw00002246

Both pipes not pointed above oil cooler

am5uuw00002985

Oil pan Assembly Note

1.Apply a continuous bead of silicone sealant to the oil pan as indicated in the figure.

Note

• Install the oil pan before the applied silicone sealant starts to harden.

belhue00000090

Caution

• Install the oil pan before the applied silicone sealant starts to harden.

• Make sure that there is no oil or dust on the seal side of oil pan.

2. Use a square ruler to unite the oil pan and the cylinder block junction side on the engine front cover side.

belhue00000091

3.Tighten the rear oil pan bolts in the order as shown in the figure.

belhue00000092

Tightening torque

17—23 N·m {1.8—2.3 kgf·m, 12.6—16.9 ft·lbf}