id011000507200

1.Measure the distortion of the cylinder block top surface in six directions as indicated in the figure.

belhue00000045

• If it exceeds the maximum, replace the cylinder block.

Cylinder head gasket contact surfaces distortion (Maximum)

0.10 mm {0.004 in}

2.Measure the cylinder bores in X and Y directions at 42 mm {1.65 in} below the top surface.

belhue00000046

• If not within the specification, replace the cylinder block.

Cylinder bore diameter (Standard)

87.500—87.530 mm {3.4449—3.4460 in}

Minimum / maximum bore diameter limit

87.440—87.590 mm {3.4425—3.4484 in}