id0102b7303800
| DTC P2610:00 |
PCM internal engine off timer performance problem |
|---|---|
|
DETECTION CONDITION
|
• The PCM internal engine off timer is damaged.
Diagnostic support note
• This is a continuous monitor (CCM).
• MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
• PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
• FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
• DTCs are stored in the PCM memory.
|
|
POSSIBLE CAUSE
|
• PCM internal engine off timer is damaged.
|
Diagnostic procedure
| STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA (MODE 2)/SNAPSHOT DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA (Mode 2)/snapshot data been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA (Mode 2)/snapshot data on repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Clear the DTC from the PCM memory using the M-MDS. (See
AFTER REPAIR PROCEDURE [L3 Turbo].)
• Start the engine.
• Perform the Pending Trouble Code Access Procedure. (See
ON-BOARD DIAGNOSTIC TEST [L3 Turbo].)
• Is the PENDING CODE for this DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”. (See
AFTER REPAIR PROCEDURE [L3 Turbo].)
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See
DTC TABLE [L3 Turbo].)
|
|
No
|
DTC troubleshooting completed.
|
||