DTC P0610:00 [L3 Turbo]

DTC P0610:00 [L3 Turbo]SM2444119

DTC P0610:00 [L3 Turbo]

id0102b7706000

DTC P0610:00	PCM vehicle configuration error
DETECTION CONDITION	• The PCM data configuration error. Diagnostic support note • This is a continuous monitor (CCM). • The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle. • FREEZE FRAME DATA (Mode 2)/Snapshot data is available. • DTCs are stored in PCM memory.
POSSIBLE CAUSE	• Configuration procedure has not been completed • PCM malfunction

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA (MODE 2)/SNAPSHOT DATA HAS BEEN RECORDED • Has the FREEZE FRAME DATA (Mode 2)/snapshot data been recorded?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA (Mode 2)/snapshot data on repair order, then go to the next step.
2	VERIFY RELATED SERVICE INFORMATION AVAILABILITY • Verify related Service Information availability. • Is any related Service Information available?	Yes	Perform repair or diagnosis according to the available Service Information. • If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	PERFORM PCM CONFIGURATION • Perform the PCM configuration. (See PCM CONFIGURATION [L3 Turbo].) • Clear the DTC from the PCM memory using the M-MDS. (See AFTER REPAIR PROCEDURE [L3 Turbo].) • Perform the KOEO or KOER self test. (See KOEO/KOER SELF TEST [L3 Turbo].) • Is the same DTC present?	Yes	Perform the PCM configuration again, then go to the next step. (See PCM CONFIGURATION [L3 Turbo].)
3		No	Go to Step 5.
4	VERIFY DTC TROUBLESHOOTING COMPLETED • Clear the DTC from the PCM memory using the M-MDS. (See AFTER REPAIR PROCEDURE [L3 Turbo].) • Start the engine. • Perform the KOEO or KOER self test. (See KOEO/KOER SELF TEST [L3 Turbo].) • Is the same DTC present?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [L3 Turbo].)
4		No	Go to the next step.
5	VERIFY AFTER REPAIR PROCEDURE • Perform the “AFTER REPAIR PROCEDURE”. (See AFTER REPAIR PROCEDURE [L3 Turbo].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [L3 Turbo].)
5		No	DTC troubleshooting completed.