DTC P0602:00 [L5]

DTC P0602:00 [L5]SM2444234

DTC P0602:00 [L5]

id0102c9705700

DTC P0602:00	PCM programming error
DETECTION CONDITION	• No configuration data in the PCM. Note • If the “PCM CONFIGURATION” is successful, the PCM stores the DTC P0602:00 and illuminates the MIL (system is normal). Clear the DTC P0602:00 using the M-MDS after the “PCM CONFIGURATION”. • The MIL goes out after three drive cycles with no failure (The DTCs remain in the PCM). Diagnostic support note • This is a continuous monitor (CCM). • The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle. • FREEZE FRAME DATA (Mode 2)/Snapshot data is available. • The DTC is stored in the PCM memory.
POSSIBLE CAUSE	• PCM configuration has not been completed • PCM malfunction

DTC P0602:00

PCM programming error

DETECTION CONDITION

• No configuration data in the PCM.

Note

• If the “PCM CONFIGURATION” is successful, the PCM stores the DTC P0602:00 and illuminates the MIL (system is normal). Clear the DTC P0602:00 using the M-MDS after the “PCM CONFIGURATION”.

• The MIL goes out after three drive cycles with no failure (The DTCs remain in the PCM).

Diagnostic support note

• This is a continuous monitor (CCM).

• The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.

• FREEZE FRAME DATA (Mode 2)/Snapshot data is available.

• The DTC is stored in the PCM memory.

POSSIBLE CAUSE

• PCM configuration has not been completed

• PCM malfunction

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA (MODE 2)/SNAPSHOT DATA HAS BEEN RECORDED • Has the FREEZE FRAME DATA (Mode 2)/snapshot data been recorded?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA (Mode 2)/snapshot data on the repair order, then go to the next step.
2	VERIFY RELATED SERVICE INFORMATION AVAILABILITY • Verify related Service Information availability. • Is any related Service Information available?	Yes	Perform repair or diagnosis according to the available Service Information. • If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	PERFORM PCM CONFIGURATION • Perform the PCM configuration. (See PCM CONFIGURATION [L5].) • Clear the DTC from the PCM memory using the M-MDS. (See AFTER REPAIR PROCEDURE [L5].) • Perform the KOEO or KOER self test. (See KOEO/KOER SELF TEST [L5].) • Is the same DTC present?	Yes	Perform the PCM configuration again, then go to the next step. (See PCM CONFIGURATION [L5].)
3		No	Go to Step 5.
4	VERIFY DTC TROUBLESHOOTING COMPLETED • Clear the DTC from the PCM memory using the M-MDS. (See AFTER REPAIR PROCEDURE [L5].) • Perform the KOEO or KOER self test. (See KOEO/KOER SELF TEST [L5].) • Is the same DTC present?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [L5].)
4		No	Go to the next step.
5	VERIFY AFTER REPAIR PROCEDURE • Perform the “AFTER REPAIR PROCEDURE”. (See AFTER REPAIR PROCEDURE [L5].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [L5].)
5		No	DTC troubleshooting completed.