id0102c9934500
| DTC P060C:00 |
Internal control module main processor performance problem |
|---|---|
| DTC P061D:00 |
Internal control module engine air mass performance problem |
|
DETECTION CONDITION
|
• Indicates an error occurred in the PCM.
Diagnostic support note
• This is a continuous monitor (CCM).
• The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
• FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
• The DTC is stored in the PCM memory.
|
|
POSSIBLE CAUSE
|
• PCM connector or terminals malfunction
• Software incompatibility issue
• PCM malfunction
|
Diagnostic procedure
| STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA (MODE 2)/SNAPSHOT DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA (Mode 2)/snapshot data been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA (Mode 2)/snapshot data on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
INSPECT PCM CONNECTOR CONDITION
• Turn the ignition switch off.
• Disconnect the PCM connector.
• Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
• Is there any malfunction?
|
Yes
|
Repair or replace the connector and/or terminals, then go to Step 5.
|
|
No
|
Reconnect the PCM connector and verify that the connector seat correctly, then go to the next step.
|
||
|
4
|
INSPECT PCM FOR LATEST CALIBRATION
• Program the PCM to the latest calibration.
• Turn the ignition switch off.
• Perform the KOEO self test. (See
KOEO/KOER SELF TEST [L5].)
• Turn the ignition switch off.
• Perform the KOER self test. (See
KOEO/KOER SELF TEST [L5].)
• Use the customer information to recreate the concern.
• Is the same DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to Step 6.
|
||
|
5
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the M-MDS. (See
AFTER REPAIR PROCEDURE [L5].)
• Perform the KOEO or KOER self test. (See
KOEO/KOER SELF TEST [L5].)
• Is the same DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
6
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”. (See
AFTER REPAIR PROCEDURE [L5].)
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See
DTC TABLE [L5].)
|
|
No
|
DTC troubleshooting completed.
|
||