ENGINE OIL REPLACEMENT [MZR-CD 2.2]

ENGINE OIL REPLACEMENT [MZR-CD 2.2]SM2444641

id0111f2800400

Warning

• Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled.

• A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work around or under a lifted vehicle if it is not securely supported on safety stands.

• Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil.

Caution

• If engine oil is spilled on the exhaust system, wipe it off completely. If you fail to wipe the spilled engine oil, it will produce fumes because of the heat.

1.Position the vehicle on level ground.

2.Remove the oil filler cap.

3.Remove the service hole cover (installed to under cover) used to drain the engine oil.

acxwzw00000906

4.Remove the oil pan drain plug.

5.Drain the engine oil into a container.

6.Install the oil pan drain plug with a new gasket.

Tightening torque

30—41 N·m {3.1—4.1 kgf·m, 23—30 ft·lbf}

Caution

• Use only the specified engine oil. Using other engine oil may cause the diesel particulate filter to deteriorate.

Note

• The amount of residual oil in the engine can vary according to factors such as the replacement method and oil temperature. Verify the oil level after engine oil replacement.

7.Refill with the following type and amount of the engine oil.

Note

• The maintenance intervals on scheduled maintenance table (See \n SCHEDULED MAINTENANCE.) can only be supported with the use of the following oils.

Recommended engine oil

Item	Specifications
Grade	ACEA C1/C2 or JASO DL-1
Viscosity (SAE)	0W-30, 5W-30
Remarks	Mazda genuine Dexelia oil (DPF) e.g.

Engine oil capacity (approx. quantity)

Oil replacement: 4.4 L {4.6 US qt, 3.9 Imp qt}

Oil and oil filter replacement: 4.7 L {5.0 US qt, 4.1 Imp qt}

Total (dry engine): 5.7 L {6.0 US qt, 5.0 Imp qt}

8.Install the oil filler cap.

9.Start the engine and confirm that there is no oil leakage.

• If there is oil leakage, repair or replace the applicable part.

10.Inspect the oil level.

• Verify that the oil level is between the F and L marks on the dipstick.

11.Install the service hole cover.

12.Connect the M-MDS to the DLC-2.

acxuuw00003283

13.Turn the ignition switch to the ON position.

14.Perform engine oil data reset procedure. (See \nENGINE OIL DATA RESET [MZR-CD 2.2].)

15.Turn the ignition switch off.

16.Wait for 20 s.

17.Turn the ignition switch to the ON position.

18.Verify that the traveled distance has been reset after the engine oil replacement, using the PID OILCHG_DIS. (See \nON-BOARD DIAGNOSTIC TEST [MZR-CD 2.2].)

—If the traveled distance has not been reset, perform the engine oil data reset again.

19.Turn the ignition switch off.