INTAKE MANIFOLD VACUUM INSPECTION [L5]

INTAKE MANIFOLD VACUUM INSPECTION [L5]SM2444695

id0113a5801500

1.Verify that the intake air hoses are installed securely.

2.Warm up the engine.

3.Disconnect the vacuum hose connecting the intake manifold and the purge solenoid valve (purge solenoid valve side) and install the vacuum gauge. (See PURGE SOLENOID VALVE INSPECTION [L5].)

4.Measure the intake manifold vacuum while idling (no load) using the vacuum gauge.

• If not within the specification, perform the following inspections.

― Accelerator cable play

― Compression pressure (See COMPRESSION INSPECTION [L5].)

― Air suction (installation areas of throttle body, fuel injector, PCV valve, intake manifold)

Note

• If any air suction exists, the change in engine speed can be made apparent by spraying the penetrant lubricating spray on the applicable part.

Standard

Approx. –70.0 kPa {–525 mmHg, –20.7 inHg}