id0114b4800900

Warning

• Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, always complete the “Fuel Line Safety Procedure”, while referring to “BEFORE SERVICE PRECAUTION”.

• A person charged with static electricity could cause a fire or explosion, resulting in death or serious injury. Before draining fuel, make sure to discharge static electricity by touching the vehicle body.

Caution

• Disconnecting/connecting the quick release connector without cleaning it may possibly cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is free of foreign material.

1.Level the vehicle.

2.Complete the “BEFORE SERVICE PRECAUTION”. (See BEFORE SERVICE PRECAUTION [L3 Turbo].)

3.Disconnect the quick release connector. (See QUICK RELEASE CONNECTOR (FUEL SYSTEM) REMOVAL/INSTALLATION [L3 Turbo].)

acxwzw00000275

4.Connect a long hose to the disconnected quick release connector and drain the fuel into a container used for collecting gasoline.

5.Drain the fuel from the fuel tank using the following procedure:

Using M-MDS

1. Connect the M-MDS to the DLC-2.

acxwzw00000276

2. Using the simulation function “FP”, start the fuel pump. (See ON-BOARD DIAGNOSTIC TEST [L3 Turbo].)

Without using M-MDS

1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [L3 Turbo].)

2. Remove the fuel pump relay.

acxwzw00000277

Caution

• Short the specified terminals because shorting the wrong terminal of the main fuse block may cause malfunctions.

3. Using a jumper wire, short fuel pump relay terminals C and D in the main fuse block.

acxwzw00001930

4. Connect the negative battery cable and operate the fuel pump. (See BATTERY REMOVAL/INSTALLATION [L3 Turbo].)

Caution

• The fuel pump could be damaged if it is operated while there is no fuel in the fuel tank. Verify the amount of fuel being discharged from the hose and stop operation of the fuel pump when essentially no fuel is being discharged.

6.Stop the fuel pump using the following procedure.

Using M-MDS

1. Using the simulation function “FP”, stop the fuel pump. (See ON-BOARD DIAGNOSTIC TEST [L3 Turbo].)

2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [L3 Turbo].)

Without using M-MDS

1. Disconnect the negative battery cable to stop the fuel pump. (See BATTERY REMOVAL/INSTALLATION [L3 Turbo].)

7.Remove the rear seat cushion. (See REAR SEAT REMOVAL/INSTALLATION.)

8.Remove the service hole cover.

acxwzw00000279

9.Remove in the order indicated in the table.

acxwzw00000280

10.Install in the reverse order of removal.

11.Complete the “AFTER SERVICE PRECAUTION”. (See AFTER SERVICE PRECAUTION [L3 Turbo].)