id0117a7800200

Warning

• Remove and install all parts when the engine is cold, otherwise they can cause severe burns or serious injury.

• When the battery cables are connected, touching the vehicle body with generator terminal B will generate sparks. This can cause personal injury, fire, and damage to the electrical components. Always disconnect the negative battery cable before performing the following operation.

Caution

• The generator can be damaged by the heat from the exhaust manifold. Make sure the generator duct is installed securely.

L.H.D.

1.Disconnect the negative battery cable.

2.Remove the drive belt. (See DRIVE BELT REMOVAL/INSTALLATION [L5].)

3.Remove the under cover.

4.Remove the exhaust manifold insulator (upper). (See EXHAUST SYSTEM REMOVAL/INSTALLATION [L5].)

5.Remove in the order indicated in the table.

6.Install in the reverse order of removal.

acxuuw00004513

Generator Removal Note

1.Remove the generator from above the engine compartment.

acxwzw00000902

Generator Installation Note

1.Tighten bolt A temporarily.

2.Tighten bolt B, C to the specified tightening torque.

3.Tighten bolt A to the specified tightening torque.

R.H.D.

1.Disconnect the negative battery cable.

2.Remove the drive belt. (See DRIVE BELT REMOVAL/INSTALLATION [L5].)

3.Remove the under cover.

4.Remove the exhaust manifold insulator (Upper). (See EXHAUST SYSTEM REMOVAL/INSTALLATION [L5].)

5.Set the brake vacuum hose out of the way. (See POWER BRAKE UNIT REMOVAL/INSTALLATION [R.H.D.].)

6.Set the brake reserve tank out of the way. (See MASTER CYLINDER REMOVAL/INSTALLATION [R.H.D. (ATX)].)

7.Set the cooler hose out of the way. (See REFRIGERANT LINE REMOVAL/INSTALLATION [MANUAL AIR CONDITIONER].) (See REFRIGERANT LINE REMOVAL/INSTALLATION [FULL-AUTO AIR CONDITIONER].)

8.Remove the insulator (power brake unit side). (See EXHAUST SYSTEM REMOVAL/INSTALLATION [L5].)

9.Remove in the order indicated in the table.

10.Install in the reverse order of removal.

acxuuw00004513

Generator Removal Note

1.Remove the generator from above the engine compartment.

acxwzw00000902

Generator Installation Note

1.Tighten bolt A temporarily.

2.Tighten bolt B, C to the specified tightening torque.

3.Tighten bolt A to the specified tightening torque.