CRUISE CONTROL SWITCH INSPECTION [MZR-CD 2.2]

CRUISE CONTROL SWITCH INSPECTION [MZR-CD 2.2]SM2444896

id0120f4800100

1.Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR-CD 2.2].)

2.Disconnect the negative battery cable and wait for 1 min or more.

3.Remove the driver‐side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION.)

4.Disconnect the clock spring connector (part wiring harness-side).

5.Inspect for resistance and continuity between clock spring connector terminals K and M (part wiring harness-side) using a tester.

• If not as specified, replace the steering switch. (See STEERING SWITCH REMOVAL/INSTALLATION.)

Switch Condition	Resistance (ohm)
Cruise OFF switch held at on	Continuity
CANCEL switch held at on	Approx. 120
SET (-) switch held at on	Approx. 300
SET (+) switch held at on	Approx. 600
RESUME switch held at on	Approx. 1,110
Cruise ON switch held at on	Approx. 2,110
Neutral	Approx. 4,310

am3zzw00005572

6.Apply battery positive voltage to clock spring connector terminal O (part wiring harness-side), and terminal E (part wiring harness-side) to ground.

acxuuw00003540

7.Verify that the LED illuminates.

• If the LED does not illuminate, replace the steering switch. (See STEERING SWITCH REMOVAL/INSTALLATION.)