FUEL PRESSURE SENSOR INSPECTION [L3 Turbo]

FUEL PRESSURE SENSOR INSPECTION [L3 Turbo]SM2444908

id0140b6801300

1.Connect the M-MDS to the DLC-2.

acxuuw00003291

2.Turn the ignition switch to the ON position.

3.Select the FUEL_PRES PID on the M-MDS.

4.After warming up the engine, verify that the FUEL_PRES PID is at the standard value under the following conditions.

― If not as verified, replace the fuel delivery pipe. (See FUEL INJECTOR REMOVAL/INSTALLATION [L3 Turbo].)

Step	Condition	FUEL_PRES PID
1	• Idle • 90 s after engine is started	Approx. 3 MPa
2	• Idle • Spill valve solenoid valve connector is disconnected	Approx. 530 kPa

5.After connecting the spill valve control solenoid valve connector, clear the DTC.