id0140e3800600

Removal

1.Disconnect the negative battery cable.

2.Perform the following procedure for easier access.

(1)Remove the under cover.

(2)Remove the splash shield.

3.Disconnect the CKP sensor connector.

4.Remove the CKP sensor.

am6xuw00001364

Installation

Caution

• When foreign material such as an iron chip is on the CKP sensor, it can cause abnormal output from the sensor because of flux turbulence and adversely affect the engine control. Be sure there is no foreign material on the CKP sensor when replacing.

1.Perform the following procedure so that cylinder No.1 is at TDC.

(1)Remove the wheel and tire (front right side).

(2)Remove the under cover.

(3)Remove the cylinder block lower blind plug and install the SST.

acxwzw00000615

(4)Rotate the crankshaft pulley clockwise until the crank weight contacts the SST so that cylinder No.1 is at TDC.

2.Fit the center of the CKP sensor with the fifth tooth (counting counterclockwise from the empty space A as shown in the figure) of the pulse wheel.

am3uuw00001031

3.Install the CKP sensor fitting bolts.

am3uuw00002966

4.Remove the SST then install the cylinder block lower blind plug.

acxuuw00004213