id0140f2444700

Using M-MDS

Note

• Use the IDS (laptop PC) because the PDS (Pocket PC) does not support the ENGINE OIL DATA RESET.

1.Connect the M-MDS to the DLC-2.

acxuuw00004334

2.After the vehicle is identified, select the following items from the initial screen of the M-MDS.

When using the IDS (laptop PC)

1. Select the “Powertrain”.

2. Select the “Data Reset”.

3.Then, select an item from the screen menu.

• Engine Oil

4.Perform the procedure according to the directions on the screen.

5.Retrieve DTC’s using the M-MDS, then verify if DTCs are present.

• If a DTC is present, perform the applicable DTC inspection.

Without using M-MDS

1.Switch the ignition to ON.

2.Short the connection between the terminals and the test terminal using a jumper wire.

acxwzw00001663

3.Repeatedly depress and release the accelerator pedal fully five times.