DTC U0300:00SM2445022
DTC U0300:00

id020200801600

DESCRIPTION

Incomplete configuration
DETECTION CONDITION
• TPMS tire identifier is a repetition error.
POSSIBLE CAUSE
• Wheel unit malfunction
― ID registration procedure has not been performed properly.
• Instrument cluster malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION
1
VERIFY PROGRAMMED ID OF WHEEL UNIT
• Switch the ignition to off.
• Connect the M-MDS to the DLC-2.
• Select the following PIDs using the M-MDS: (See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS.)
― WU1_ID
― WU2_ID
― WU3_ID
― WU4_ID
• Switch the ignition to ON.
• Is the same code in the output ID?
Yes
Configure the instrument cluster, then go to the next step.
(See INSTRUMENT CLUSTER CONFIGURATION.)
No
Go to the next step.
2
VERIFY TROUBLESHOOTING COMPLETED
• Clear the DTC from the instrument cluster memory using the M-MDS. (See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS.)
• Drive the vehicle at speed of 25 km/h {15.5 mph} or more for 10 min or more.
• Retrieve the TPMS DTC using the M-MDS. (See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS.)
• Is the same DTC present?
Yes
Replace the instrument cluster, then go to the next step.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
No
Go to the next step.
3
VERIFY THAT NO OTHER DTCs ARE PRESENT
• Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS.)
No
DTC troubleshooting completed.