id021300800600

Caution

• Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.

Note

• For this vehicle, a spacer is present/not present on the steering knuckle. After verifying whether the spacer is equipped or not, perform the removal/installation using the following procedure.

• There is no problem with the left or right steering knuckle having either a spacer or no spacer.

1.Remove the under cover.

2.When working on the left side of the vehicle, remove the front auto leveling sensor installation bolt. (Vehicle with front auto leveling sensor) (See FRONT AUTO LEVELING SENSOR REMOVAL/INSTALLATION.)

3.Remove in the order indicated in the table.

4.Install in the reverse order of removal.

5.Perform the auto leveling system initial setting. (See AUTO LEVELING SYSTEM INITIALIZATION.)

acxwzw00002168