id0312008004a2

Caution

• Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (body side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle.

1.Remove the rear ABS wheel-speed sensor. (See REAR ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATION [4WD].)

2.Remove the rear stabilizer. (See REAR STABILIZER REMOVAL/INSTALLATION.)

3.Remove the rear coil spring. (See REAR COIL SPRING REMOVAL/INSTALLATION.)

4.Remove the trailing link. (See REAR TRAILING LINK REMOVAL/INSTALLATION [4WD].)

5.Remove in the order indicated in the table.

6.Install in the reverse order of removal.

acxwzw00001417