id031400800800

1.Drain the differential oil into a container.

2.Remove the propeller shaft. (See PROPELLER SHAFT REMOVAL/INSTALLATION.)

3.Remove the locknut using the SST.

acxuuw00003044

4.Support the differential using a jack.

Caution

• Excessively tilting the differential may cause it to interfere with the crossmember and to be damaged. Be careful when tilting the differential.

5.After removing the front side of the differential mount, gradually lower the jack and tilt the front side of the differential downward.

acxuuw00003045

6.Pull the companion flange off using the SST.

acxuuw00003046

7.Remove the oil seal from the differential carrier using a screwdriver or similar tool.

8.Apply differential oil to the new oil seal lip.

Note

• Install the oil seal at a straight angle.

9.Install the new oil seal to the differential carrier using the SST.

acxuuw00003047

Substitution SST

• 49 W011 102 Outer diameter: 66 mm {2.60 in} or more Inner diameter: 54—60 mm {2.13—2.36 in} or more Inner depth: 17.5 mm {0.69 in} or more

10.Install the companion flange to the drive pinion.

11.Jack up the differential and install the front side of the differential mount.

12.Install the washer and a new locknut.

13.Tighten the locknut to the specified torque using the SST.

acxuuw00003132

14.Install the propeller shaft. (See PROPELLER SHAFT REMOVAL/INSTALLATION.)

15.Add the specified differential oil from the filler plug. (See DIFFERENTIAL OIL REPLACEMENT.)