 |
acxwzw00000606
id031500800300
1.Remove the middle pipe, and front pipe. (L3 Tubo) (See EXHAUST SYSTEM REMOVAL/INSTALLATION [L3 Turbo].)
2.Remove the SCR converter, middle pipe and oxidation catalytic converter. (MZR-CD 2.2) (See EXHAUST SYSTEM REMOVAL/INSTALLATION [MZR-CD 2.2].)
3.Remove in the order indicated in the figure.
4.Install in the reverse order of removal.
acxwzw00000606
|
|
1
|
Balk head plate
|
|
2
|
Center stay (MZR-CD 2.2)
|
|
3
|
Bolt
(See
Bolt and Nut Removal Note.)
|
|
4
|
Nut
|
|
5
|
Bracket
|
|
6
|
Bush, spacer
|
|
7
|
Nut
|
|
8
|
Bush, spacer
|
|
9
|
Nut
(See
Bolt and Nut Removal Note.)
|
|
10
|
Propeller shaft
|
Bolt and Nut Removal Note
1.Before removing the nut, place alignment marks on the companion flange (front) and constant velocity joint, and on the companion flange (rear) and yoke.
acxuuw00003095
|
Propeller Shaft Installation Note
1.Align the alignment marks and install the propeller shaft.
acxuuw00003095
|
2.When installing a new propeller shaft, align the rear differential companion flange mark with the tag on the propeller shaft so that they are at the nearest position, and assemble.
acxuuw00004545
|
3.Perform a road test and verify that there is no abnormal vibration or noise.
