1.If any brake line has been disconnected during the procedures, add brake fluid, bleed the brakes, and inspect for leakage after the procedure has been completed.
Caution
• Brake fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. If it is spilled, wipe it off immediately.
Brake Pipe Flare Nut Tightening
1.Tighten the brake pipe flare nut using any commercially available flare nut wrench.
1.Make sure that there are no DTCs in the DSC memory after working on DSC related parts. If there are any DTCs in the memory, clear them. (See ON-BOARD DIAGNOSIS.)
DSC Related Part Sensor Initialization Procedure
Warning
• If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, when replacing or removing the following parts, make sure to perform the initialization procedure to insure proper DSC operation.
• Unless the initialization procedure of the steering angle sensor is completed, the DSC will not operate, causing an unexpected accident. Therefore, always perform the initialization procedure to ensure DSC operation if the power supply to the BCM has been cut off due to disconnection of the BCM connector or negative battery cable, or any other cause.
Caution
• The steering angle sensor initialization value of the BCM is stored using the battery power supply. Therefore, the battery power supply of the BCM is cut and the stored steering angle initialization value is cleared when any of the following items are performed.
• If the initialization procedure for the steering angle sensor has not been performed, when the ignition switch is turned to the ON position, the DSC indicator light illuminates and the TCS OFF light flashes to warn of a malfunction.
