ON-BOARD DIAGNOSTIC SYSTEM SIMULATION INSPECTION [AW6A-EL, AW6AX-EL]SM2445296
ON-BOARD DIAGNOSTIC SYSTEM SIMULATION INSPECTION [AW6A-EL, AW6AX-EL]

id0502j7290400

1.Connect the M-MDS to the DLC-2.
acxuuw00003706

2.After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

• When using the IDS (laptop PC)
1. Select “DataLogger”.
2. Select “Modules”.
3. Select “TCM”.
• When using the PDS (Pocket PC)
1. Select “Module Tests”.
2. Select “TCM”.
3. Select “DataLogger”.

3.Select the active command modes from the PID table.

4.Perform the active command modes, inspect the operations for each parts.

• If the operation of output parts cannot be verified after the active command mode inspection is performed, this could indicate the possibility of an open or short circuit, sticking, or operation malfunction in the output parts.

Simulation item table

Item

Related to

Unit/Condition

Test condition
LPS
Pressure control solenoid
A
Ignition ON or idling (P or N position)
SSA
Shift solenoid A
On/Off
Ignition ON or idling (P or N position)
SSB
Shift solenoid B
On/Off
Ignition ON or idling (P or N position)
SSC
Shift solenoid C
A
Ignition ON or idling (P or N position)
SSD
Shift solenoid D
A
Ignition ON or idling (P or N position)
SSE
Shift solenoid E
A
Ignition ON or idling (P or N position)
SSF
Shift solenoid F
A
Ignition ON or idling (P or N position)
TCCC
TCC control solenoid
A
Ignition ON or idling (P or N position)